PREPARATION OPERATION MAINTENANCE APPENDIX
PLEASE READ WITHOUT FAIL
CONTENTS
INTRODUCTION .................................................... 1
PLEASE READ WITHOUT FAIL
[1] Operating Precautions ............................ 10
1-1. DANGER ........................................... 10
1-2.
WARNING ......................................... 11
1-3.
CAUTION .......................................... 13
[2] Parts Identification ................................... 15
2-1. Main Body ................................................. 15
2-2. Support Column ....................................... 16
2-3. Operation Panel ....................................... 17
PREPARATION
[3] Preparation before Use ........................... 20
3-1. Where to install the Unit .......................... 20
3-2. Locking the Casters ................................. 20
3-3. Adjusting the Hi-Low Stand .................... 21
3-4. Power Outlet and Grounding.................. 22
3-5. Power Cord and Power Switch .............. 22
3-6. Power Failure Alarm ................................ 23
3-7. Daily Inspection ........................................ 24
OPERATION
[4] Heat Control ............................................... 25
4-1. Setting the Heater Output
(Manual Control) ...................................... 25
4-1-1. Setting Preheating
(Manual Control) ....................... 26
4-1-2. Skin Temperature
Monitoring (Skin
Temperature Probe:
Yellow and White) ..................... 27
4-1-3. Heater Output Indicator ........... 29
4-2. Setting the Skin Temperature
(Servo Control) ......................................... 29
[5] Pulse Oximeter .......................................... 32
5-1. Attaching the Sensor ............................... 32
5-1-1. Connecting the Patient
Cable to the Main Body ........... 33
5-2. Setting the Upper/Lower Alarm Limits .. 33
5-3. Setting the Sensitivity (Masimo) ............ 34
5-4. Setting the Synchronizing Pulse
Beep Volume and the Averaging Time .. 35
5-5. SatSeconds (Nellcor) .............................. 35
5-6. Setting the Fast Response (Nellcor) ..... 36
5-7. Turning on/off the Pulse
Oximetry Function ................................... 37
[6] Tilting the Mattress Platform ................. 38
6-1. Operating the Mattress Platform ........... 38
[7] Other Operation Procedures ................. 39
7-1. Timer .......................................................... 39
7-1-1. Operating the Timer ................. 39
7-1-2. Setting the Timer Mode ............ 39
7-2. I/O Port (Communication Connector) ... 40
7-3. Lighting ...................................................... 41
7-4. Rotating/Tilting the Canopy .................... 41
7-5. Baby Guard ............................................... 42
7-6. Support Column Rail ............................... 42
7-7. X-ray Cassette Tray .................................. 43
7-8. Setting the Alarm Volume ....................... 44
7-9. Changing the Temperature
Deviation Limit of the Set
Temperature Alarm .................................. 44
7-10. Enabling/Disabling the Key Click ........... 45
MAINTENANCE
[8] Cleaning and Disinfection ...................... 46
8-1. Main Body ................................................. 46
8-2. Others ........................................................ 47
[9] Maintenance Inspection.......................... 48
9-1. Inspection before Use ............................. 49
9-2. Quarterly Inspection ................................ 51
9-3. Periodical Replacement Parts ............... 51
9-4. Inspection Checklist ................................ 52
9-5. Disposal .................................................... 53
[10] Alarms ......................................................... 54
[11] Troubleshooting ........................................ 58
APPENDIX
[12] Technical Data ........................................... 59
To Next Page
Loading...
