Preparation before Use[3]
Where to install the Unit3-1.
Install the unit on a horizontal surface in a convenient location. Avoid installing it near a heating apparatus, by
the window, or where fire is used.
Since the radiant temperature on the bed of the unit is affected by the ambient temperature, the unit should
be used in a room whose temperature is 18∼30°C. Be careful not to cause large fluctuations in room tem-
perature.
Avoid installing the unit in direct sunlight, near a stove or a radiator, in the direct airflow of an air
conditioner, or by a cold window so that it may not be affected directly by such external thermal
conditions.
The unit should be at least 150cm away from a heating apparatus. Avoid installing it near the air
outlets of an air-conditioner or where it will be exposed to an excessive draft.
Since the heat of the heater is radiated from the top surface of the canopy as well, the top surface
of the canopy should be at least 30cm below the ceiling.
Locking the Casters3-2.
(1) Install the unit in a desired place and lock the cast-
ers.
To lock a caster, lower the stopper on the caster to (2)
the locking position.
To unlock a caster, raise the stopper.(3)
Install the unit on a horizontal and stable floor.
●
Step on the stoppers to lock the casters securely.
To move the unit to another place, be sure to
unlock the casters.
To Next Page
Loading...