42
Other Operation Procedures
Baby Guard7-5.
Check periodically that the baby guards are locked securely.
When you pull up and lock the baby guards in position, be sure to check that no mattress or linen is
caught between any of the baby guards and the mattress platform. Make sure that the baby guards
are locked securely. If linen or other object is caught between any of the baby guards and the mat-
tress platform, remove it. Otherwise, the baby guards will not be locked completely. The baby guards
may swing down and the infant may fall out of the unit and suffer serious or fatal injury.
If the baby guards are left folded down, the infant may fall out. Do not leave the unit unattended with
the baby guards folded down.
If the infant is very active, keep your eye on the infant and don’t leave the unit.
All the baby guards except for the one on the support
column side can be folded down.
To fold down a baby guard, pull it up and then toward
you. To return it to its former position, pull it up until it
becomes vertical and then lower it down to lock.
Support Column Rail7-6.
When mounting optional accessories to the support column rails, make sure that the unit is in a
horizontal position. The load on one support column rail must not exceed 20kgf and the total load
must not exceed 30kgf.
When mounting an optional accessory to the rail, pay attention to the overall balance of the unit so
that it may not overbalance.
When moving the unit to another place, it might overbalance if one or more optional accessories
are mounted to it. Pay utmost attention when moving it in this condition.
When mounting an optional accessory to the support column rail, make sure that it is fixed securely
to the support column rail.
For further information on mounting an optional accessory to the support column rail, refer to the
relevant instructions provided with the accessory.
To Next Page
Loading...
