49
MAINTENANCE
Maintenance Inspection
Inspection before Use9-1.
If you should notice any strange smell, strange noise, overheating, strange vibration, missing parts,
or defective function in the inspection, stop using the unit immediately and contact your local Atom
representative.
Check the following points every time you are going to use the unit.
If you should notice any defect, contact your local Atom representative.
Check the following points before connecting the power cord.(1)
Item to check Description
Appearance No part of the main body should be broken.
Power cord The plug should not be deformed. The cord should not be damaged.
Power connection The power connections should be clean with no medical fluid stains.
Caster The casters should rotate smoothly. They should be locked reliably.
Baby guard
The baby guards should be attached securely to the mattress platform.
No hinge should be broken.
Tilting unit The mattress platform should be locked reliably in a tilted position.
Probe connecting port
The area around the probe connecting ports should be clean and should
not be broken.
Control knob
The control knobs should be attached securely and should operate reli-
ably.
Reflector The reflector should be clean and should not be damaged.
Canopy tilting mechanism The canopy should be held in place securely when tilted.
Canopy fixing screw The screw should be attached securely where it should be.
Power failure alarm
The power failure alarm should activate when the power switch is turned
on.
Tube introduction slit packing
The packings should be attached correctly to the baby guards and they
should not be broken.
Caution/Warning sticker
Each sticker should be affixed securely. (Otherwise, important safety
information will not be made known appropriately.)
Operation Manual It should be kept where it is readily accessible.
To Next Page
Loading...
