21
Engine break-in period
The initial break-in period of the engine is very important. Failure
to follow the break-in procedure (or other improper operation) will
cause vehicle malfunction or damage.
1) An engine that has been operated per the break-in procedure
can result in a lifetime improvement in engine performance.
2) A properly run-in engine will result in longer lifespan of en-
gine parts, and extend the service life of the engine.
3) Requirements
• Never operate at full throttle during the first 800 km of opera-
tion.
• Operate the motorcycle at less than 6000rpm in all gears for
the first 800 km.
• Do not overload the engine with excessive weight during the
first 800 km.
Engine Maintenance
When the engine has been run-in for 500 miles, a mandatory first
service and inspection is required to be performed by an author-
ized Genuine Service Center to maintain the limited warranty that
may apply.
1) Replace the engine oil
2) Valve gap inspection and adjustment
3) Inspect the spark plug, adjust the gap and clean any carbon
deposits.
4) Tighten all fasteners
5) Clean the air filter or replace if necessary
6) Adjust chain tension
7) Check tire pressure. Add air if necessary.
8) Check free-play on vehicle controls. Adjust and lubricate
levers / cables as necessary.
9) Complete any other routine maintenance or repair any ob-
served trouble condition that may exist.
To Next Page
Loading...