30
10W/30-SF in winter
Caution
The insufficiency or poor quality of the engine oil will lead to the
premature wear-out of the engine.
Substitution of the engine oil
Engine oil plays a very important role in the normal operation of
the engine and for that reason, it is necessary to check the mo-
torcycle for Engine oil periodically and renew the oil once every
800-1000 km of drive by the following procedures.
Note: When replacing the engine oil, please clean the short and
long oil rulers and to replace with both oil filters. The engine oil
should be replaced at an operating temperature.
Unscrew the draining nut when the engine is hot and then drain
the old engine oil.
Clean the filter and then install. Fill with 1.1L new engine oil. Start
the engine for idle running with 2-3 minutes.
Check whether or not the engine oil level is among the lowest
and highest level of the oil ruler.
Caution:
When the engine is at a operating temperature, the engine oil
might be very hot, so do not make yourself burnt.
Place the motorcycle flatly, take off the plug, then fill the engine
oil in the container. Clean the plug thoroughly.
Since all the oil has been used up, clean the gasket and tighten
the gasket and plug together to 20
－
30N.m
Oil ruler must be mounted properly, or the oil ruler will fail to
Machine oil gauge
Screw plug for oil
draining
To Next Page
Loading...