ATX TranScend - Plug-in Commands

CRAFT LINE INTERFACE (CLI)
5-2 TranScend Chassis – Operation Manual
Common Commands:
help uptime info logout status
alarm DownloadStatus slot SwVer HwVer
ModelName SerialNum Network Download Reboot
Date Hostname Community TrapAddr sysContact
sysLocation PowerAlarm FanAlarm
Example #2: display individual help description.
Transcend [slot-1] >help network
Network:
Set/Get network conguration.
Syntax: Network <ip netmask gateway >
No argument: Display network conguration.
With all 3 arguments: Congure network.
Uptime: Displays the number of seconds accumulated since chassis boot up.
Example #1:
Transcend[slot-1] >uptime
820 seconds (0 days 0 hours 13 min 40 sec)
info: Displays the system and selected plug-in factory information.
Example #1: The rst part is System factory information and followed by the factory information of plug-in in slot 1.
Transcend [slot-1] >info
System
SwVer:
2.0-2.0
HwVer:
1-1
ModelName:
TSD-CH-AC
SerialNum:
24521210
Slot 1 (HS-QRRX)
SwVer:
2.0-2.0
HwVer:
1-1
ModelName:
TSD-RRX4-HS-EP
SerialNum:
25200111
logout: Logs the remote user off and close the current CLI session. This command has no effect on the CLI via front panel
console port.
CHAPTER 5: