ATX TranScend - RF Switch LCD Menu

FRONT PANEL LCD DISPLAY
TranScend Chassis – Operation Manual 4-11
iHub: Displays the detected I-HUB status. The display reads “Empty” when no I-HUB is detected or “IHUB” if an I-HUB is
detected.
Topology Setup:
Number of iHubs: The maximum number of I-HUBs is managed by this proxy agent. The number is xed as “1”
for Destacker type of proxy.
Save: Press “Right” or “Left” button to select between “Yes” or “No”. Press “Select” to commit the value into
NVRAM when “Yes” is selected. The value in bracket reects the current NVRAM contetns. If user presses “Select”
when the display is “No”, no NVRAM change takes place.
Alarm Menu:
Module Temp: Displays the module temperature alarm status.
SFP: Displays the I-HUB front plug in SFP alarm status. This alarm is unavailable for Destacker type of proxy.
Prev Menu:
Press “Select” will bring back to the greeting menu.
Chassis Menu:
Temp(C): Displays the module’s temperature reading in Centigrade.
Model: Displays the model name of plug-in module.
HW Ver: Displays the hardware version information of plug-in module.
SW Ver: Displays the software version information of plug-in module.
Ser #: Displays the serial number of plug-in module.
Prev Menu:
Press “Select” will bring the plug-in’s greeting message screen back.
4.3.6 Stacker
Level 1 Level 2 Level 3 Level 4
Greeting Setup Test Point Menu Sel Channel
Prev Menu
Prev Menu
Alarm Synthesizer Lock
Optical Power
Laser Temperature
Module Temperature
Prev Menu
Optical Optical Power (dBm)
Laser Temperature (C)
Attn (dB)
Prev Menu
CHAPTER 4: