ATX TranScend - Opto-Stacker CLI Commands

CRAFT LINE INTERFACE (CLI)
5-16 TranScend Chassis – Operation Manual
RFPower (dBmV):
[1] -42.1 [2] -99.9
Switch:
Secondary
thresholddBmV (dBmV):
+30.0
Alarm:
Transcend[slot-1] >alarm
System
PowerAlarm:
Normal
FanAlarm:
Major
Slot 1 (RF-Switch)
SwitchAlarm:
Major
RFPowerAlarm:
[1] MajorLoLo [2] MajorLoLo
ModuleTempAlarm:
Normal
5.1.2.10 AGC EDFA
The AGC EDFA describes in this document applies to the rmware release 1.21 or later. The commands in this section are
AGC EDFA specic.
OPinPower: Displays the optical input power reading in dBm.
Example #1: In this example, the module in slot 1 reports its optical input power reading.
Transcend [slot-1] >OPinPower
-99.0 (dBm)
OPoutPower: Displays the optical output power reading in dBm.
Example #1: In this example, the module in slot 1 reports its optical output power reading.
Transcend [slot-1] >OPoutPower
-99.0 (dBm)
GainControl: Displays the gain control mode.
Example #1: In this example, the module in slot 1 reports its gain control mode.
Transcend [slot-1] >gainControl
AGC
Gain: Displays the gain reading in dB.
Example #1: In this example, the module in slot 1 reports its gain reading.
CHAPTER 5: