CRAFT LINE INTERFACE (CLI)
TranScend Chassis – Operation Manual 5-23
Transcend[slot-1] >WaveLength
1546.12 nm
GainOffset: Displays the gain offset reading in steps.
Example #1: In this example, the module in slot 1 reports its gain offset reading.
Transcend [slot-1] >gainoffset
-20 steps
GainControl: Displays the gain control mode setting.
Example #1: In this example, the module in slot 1 reports its gain control mode.
Transcend [slot-1] >gaincontrol
MGC
Attenuation: Displays the attenuation setting in dB.
Example #1: In this example, the module in slot 1 reports its attenuation setting as 0 dB on channel 1.
Transcend [slot-1] >attenuation 1
0 (dB)
FiberLength: Displays the transmit ber length setting in kilometer.
Example #1: In this example, the module in slot 1 reports its transmit ber length.
Transcend [slot-1] >FiberLength
20 km
LaserTempAlarm: Displays the alarm status of laser temperature.
Example #1: In this example, the module in slot 1 reports the alarm status of laser temperature on channel 1 as
“MajorLoLo” (e.g. Major alarm with power reading below the low low threshold).
Transcend [slot-1] >LaserTempAlarm 1
MajorLoLo
LaserPowerAlarm: Displays the alarm status of laser power.
Example #1: In this example, the module in slot 1 reports the alarm status of laser power as “MajorLoLo” (e.g.
Major alarm with reading below the low low threshold).
Transcend [slot-1] >LaserPowerAlarm
MajorLoLo
LaserRfAlarm: Displays the alarm status of laser RF.
CHAPTER 5:
To Next Page
Loading...
