29
Channel Features
Channel Name
By double-clicking on the name of the channel
you can rename it to help you organise your
iD Software Mixer. You could name a channel
‘Kick’ or ‘Snare’ for example.
+10dB Boost
Selecting this will boost the incoming signal
by +10dB for recording quiet sources. This will
also aect the audio being fed into your DAW.
Phase Flip
Inverts the polarity of the signal by 180° to
stop phase cancellation. This is useful if you
are micing the rear of a guitar amplifier or the
underside of a snare drum.
Pan Control
Allows you to send the audio to the left, to
the right or anywhere between on your Main
Monitor Mix or Cue Mixes.
Stereo Grouping
Allows you to group two adjacent channels
together into a stereo channel with a single
fader controlling the level of both channels.
When a channel is stereo grouped, the pans
will automatically be set to hard left and
hard right.
Solo
The Solo button mutes all other channels
other than the one that is currently soloed.
Multiple channels can be soloed at one time.
Mute
The Mute button stops this channel from
outputting audio whilst it is engaged.
Fader
The fader controls the amount of signal that
is sent to the currently selected mix. This can
be set to anywhere between -inf dB to +6dB.
Meter
The meter shows the current signal level in
dBFS. Should the signal level exceed 0dBFS
then the peak indicators will illuminate red to
indicate a peak. The peak indicators can be
turned o by clicking on them. You can also
turn o all peak indicators using Alt + Click.
To Next Page
Loading...
