Audio Ltd. Envoy - Page 14

88
14
CXiR Receiver
• Repeat the above steps if an error message is
displayed, with the Switch
iR closer to the receiver.
Setting the output level
The CX iR should be set to the correct level as required
by the camcorder. The output level is attenuated in 1dB
steps over a 32dB range. The 0dB reference level is
-25dBu.
To check the CX
iR output level:
• Press MENU.
• Press a once until
the display shows:
AF LEVEL
TxRx
AF
• Align the front of the Switch iR with the infra-red port
on the receiver and press OK.
The display will show the current
output level setting; for example:
AF LEVEL
Rx
-07 dB
To change the receiver output level:
• Press the OK button.
The AF level display will flash.
• Press the a or v button to step between the
available output level settings until the required
output level is displayed.
For example:
AF LEVEL
TxRx
-15 dB
• Align the front of the Switch iR with the infra-red port
on the receiver and press OK.
If the command was received correctly the new level
will be displayed.
For example:
AF LEVEL
TxRx
-15 dB
Otherwise the display will show:
Error
• Repeat the above steps if an error message is
displayed, with the Switch
iR closer to the receiver.
CXiR Receiver