Audio Ltd. Envoy - Indicators and Power Management

88
15
CXiR Receiver
Checking the DC power status
To check the status of the receiver’s DC power:
• Press MENU.
• Press a three times until
the display shows:
TxRx
BAtt
• Align the front of the Switch iR with the infra-red port
on the receiver and press OK.
The display will
show the DC voltage:
Rx
11.9 v
If the associated transmitter is on while the DC status is
being checked the display will alternate between the
receiver’s DC status and the received transmitter DC
status.
For example:
Tx
H
The transmitter status is shown as one of the following
options:
Option Description
H (high) Indicates good.
L (low) Indicates low. Replace as soon
as possible.
F (failed) Transmitter will not function
correctly.
Indicators during operation
The CX iR should switch between the RX1 and RX2
receivers for best reception, as indicated by the yellow
RX1 and RX2 indicators on the top of the unit.
The red no-signal indicator will be lit if the
corresponding HX
iR or TX Blue transmitter is not
switched on, or is set to the incorrect frequency. The
amber indicator will be lit if the TX battery goes low.
External powering
A number of different cables and accessories are
available from Audio Limited to allow the CX
iR receiver
to be externally powered.