88
38
AudiR Infra-Red
Controller
In each case click the Update button to send the new
settings to the device.
Tx Off (transmitter only): Allows you to power off the
transmitter.
IR Off: Allows you to disable the infra-red receiver.
Displays the following confirmation dialog box:
• Tap the Yes button to disable the iR communications
or the No button to cancel.
Once the infra-red has been disabled any further use of
the Switch
iR
will result in an error message.
If the infra-red has been disabled the only way to
enable it is to interrupt the power to the device.
Plot signal
Shows a continuous plot of the signal strength for each
of the two diversity receivers:
This allows you to see the effect of transmitter position
on the received signal strength for evaluating the range
and positioning receiver antennae to optimise system
performance.
Scan
Plots a frequency scan to allow you to evaluate the
amount of interference on the chosen frequency:
To Next Page
Loading...