40
Setting from RF scan results
After RF scanning at the receiver, frequency setting can be made from the scan data synchronized
via IR SYNC. See
“Performing RF scan” (p.28) for more
information on RF scanning.
1
From the menu screen, turn the control dial, select “FREQUENCY” and then press the control dial.
2
Select “RX SCAN DATA” and press the control dial.
3
Select a group and press the control dial.
• Select “FULL SCAN DATA
”
to show and confirm scan results in a graph.
• Select “RESET” to delete the scan results.
4
Select a channel and press the control dial.
• When “DEPLOY” is selected, the frequency channel of the selected group are shared to transmitters in the same
network, allowing you to change the settings of multiple units simultaneously at one time. For details, see
“Using the deploy Function” (p.33).
The setting is complete.
Setting the channel name (NAME)
The number of characters that can be entered is 8. The characters that can be set are as follows:
• Alphabetic (uppercase letters)
• Numeric
• Symbols (_, +, -, #, &, period)
• Space
1
From the menu screen, turn the control dial to select “NAME” and press the control dial.
2
Turn the control dial, select the desired character, and then press the control dial.
The character is input, and the cursor moves.
3
Repeat the operation in Step 2 to enter all characters.
4
Turn the control dial, select “End” and then press the control dial.
The setting is complete.
To Next Page
Loading...
Need help?
General
