Hardware Installation Manual 52 Document #: LTRT-10764
Mediant 500 MSBR
5.8 Connecting a USB Storage Device
The device supports USB storage capabilities, using an external USB hard drive or flash
disk (disk on key) connected to the device's USB port. The storage capabilities are
configured through CLI and include the following:
Saving network captures to the USB.
Upgrading the device's firmware from the USB.
Updating the device's configuration from the USB.
Saving the current configuration to the USB.
To connect the USB storage device:
Connect the USB storage device to one of the USB ports located on the front panel.
Figure 5-21: Connecting USB Storage Device
Note: Only a single USB storage (formatted to FAT/FAT32) operation is supported at any
given time.
To Next Page
Loading...
