Autel MaxiSys ADAS - VCI Manager; Connection Mode

81
9 VCI Manager
This application allows you to pair the tablet with the VCI device, MaxiFlash
Elite, and to check the communication status.
Figure 9-1 Sample VCI Manager Screen
1. Connection Mode – there are two connection modes available for
selection. The connection state is displayed alongside.
 BT Pairing – when paired to a wireless device, the connection state
displays as Paired; otherwise it displays as Unpaired.
 Update (for VCI software only) – updates VCI software via Internet through
the MaxiSys tablet networking using USB connection.
 Select a connection mode to manage and set up connection.
2. Settings – this section allows you to manage wireless pairing or set up
network connection.
 BT Setting – searches and displays the type and part serial number for all
of the devices available for pairing. Tap a required device to start pairing.
The BT status icon displayed to the left of the device name indicates the
received signal strength.
 Ethernet Setting – allows you to perform network configuration.