• If needed, add adjustment shims under the housing to obtain the correct levelling of the barrier.
Only tighten the nuts (36) after the installation of the arm ( Chap. 6.4, page 21) and the optional tip support
( Chap. 6.5, page 25).
ATTENTION! THE FOLLOWING PROCEDURE MUST BE PERFORMED PRIOR TO OPERATING YOUR GATE. FAILURE TO DO SO
WILL VOID THE MANUFACTURER’S WARRANTY AND RESULT IN PERMANENT DAMAGE TO YOUR EQUIPMENT.
• This equipment’s gearbox has been sealed with a plug for transportation purposes. The plug must be replaced with the
vented plug located in the plastic bag fixed on the gear motor (Ref. 19, Fig. 2, page 9).
Fig. 8 - Plug to change on the reducer
ONCE THE VENTED PLUG HAS BEEN INSTALLED, THE BARRIER MUST REMAIN IN THE UPRIGHT POSITION FOR TRANSPORT
OR HANDLING PURPOSES. FAILURE TO DO SO WILL CAUSE OIL IN THE GEARBOX TO LEAK WHICH MAY CAUSE PREMATURE
WEAR OF THE GEARBOX.
17
BL 229
To Next Page
Loading...