• Vehicles equipped with a
Power Steering Pressure
Switch - Turn the steering
wheel 1/2 turn and release,
when prompted.
• Vehicles equipped with a Brake
ON/OFF Switch - Press and
release the brake, when
prompted.
7. If the vehicle is equipped with an
automatic transmission, place the
car into Drive and then back into
Park, when prompted.
8. If Dynamic Response is dis-
played, briefly accelerate the engine
to wide open throttle, and release.
(Snap throttle)
9. After the scanner has completed
the KOER scan, the
Scan
Successful
message will be displayed on the screen, fol-
lowed by the opening screen.
• If these steps are not completed correctly, the engine comput-
er will store a Trouble Code as if the system was not function-
ing properly. If one of these trouble codes are stored, repeat
the scan with the necessary steps to eliminate the problem.
For example, the error
RPM too low during KOER
test
can be
corrected by pressing the gas pedal to the floor during the
Dynamic Response section of the scan.
Page 37
! Scan !
*Successful*
AutoXray 6000
FORD ‘90 VIN=N
SCAN THE KOEO CODES - FORD (CONT.)
To Next Page
Loading...
