Assembling the deskphone
Issue 5 August 2014 27
Assembling the deskphone
!
CAUTION:
CAUTION: Be careful to use the correct jack when plugging in the deskphone. The jacks are
located on the back of the deskphone housing and are flanked by icons to
represent their correct use.
Powering the IP deskphone
The 9601, 9608, 9608G, 9611G, 9621G, and 9641G deskphones support IEEE
802.3af-standard LAN-based power. Before installing a 9601, 9608, 9608G, 9611G, 9621G, or
9641G deskphone, verify with the LAN administrator whether the LAN supports IEEE 802.3af,
and if so, whether the deskphone should be powered locally or by means of the LAN.
When you add devices like multiple button modules, all of which must be the same model type,
to applicable IP deskphones, the power class might change.
Note:
Note: The 9601 and 9621G IP deskphones do not support button modules.
H.323-centric H.323 factory set SIP Connect the deskphone to a power source and to
the network.
Press the Program softkey as soon as it displays
in the first softkey position to access the Craft
Access Code Entry screen. Perform the SIG
Craft procedure and change the value from
“default” to “2" (SIP).
Save the SIG parameter change. The deskphone
will reset if necessary to get the appropriate
software.
H.323-centric SIP H.323 Perform the SIG Craft procedure to change the
SIG parameter value from “2" (SIP) to “default”
(H323). For information, see Setting the signaling
protocol identifier on page 58.
Save the SIG parameter change. The deskphone
will restart if necessary to get the appropriate
software.
Table 1: H.323 to SIP and SIP to H.323 conversion chart (continued)
Environment To convert this
type of
deskphone
To this
type of
deskphone
Then
To Next Page
Loading...
