Local administrative options
44 SIP Deskphones Release 6.4 Installation and Maintenance Guide
About local administrative procedures
Craft procedures allow you to customize the IP deskphone installation for your specific
operating environment on a deskphone-by-deskphone basis. This section provides a
description of each local administrative option covered in this guide, with references to the
pages on which the option appears.
Note:
Note: When running a local (Craft) procedure from the touch screen-based
deskphones, simply "touching" a line or a softkey produces the same result as
selecting a line or a softkey on non-touchscreen (button-based) IP deskphones.
Unless otherwise prohibited using administration, a user can view but not change
most of the parameters associated with Craft procedures. For more information,
see the applicable users guides.
Shown As Craft Procedure Purpose See
802.1X Set the 802.1X operational
mode
Setting the 802.1X operational
mode on page 45.
ADDR Network Address information
programming
Installing static addressing on
page 47.
AGC Enable/disable Automatic Gain
Control
Enabling and disabling Automatic
Gain Control on page 49.
CALIBRATION Calibrate the touchscreen
(9621G and 9641G models
only)
Calibrating the touch screen on
page 49.
CLEAR Clear all values to factory
defaults
Using the Clear procedure on
page 50.
DEBUG Enable/disable Debug Mode Enabling and disabling Debug
Mode on page 51.
GROUP Set the Group Identifier
Setting the Group identifier on
page 52.
HANDSET EQ Set the handset equalization. Setting handset audio
equalization on page 54.
INT Network Interface Control
Setting interface control on page 54.
LOG Enable/disable Event Logging Enabling and disabling event
logging on page 55.
LOGOUT Log off the deskphone
Logging out on page 57.
To Next Page
Loading...
