Local administrative options
54 SIP Deskphones Release 6.4 Installation and Maintenance Guide
Setting handset audio equalization
Use the following procedure to configure the Handset Equalization settings:
1. On the user menu, navigate to Settings > Options&Settings > Advanced Options >
Handset Equalization.
2. Using the navigational keys or by tapping the arrow icons on the screen, choose any of the
following:
- Default
- Audio Opt
- HAC Opt
3. Press Save.
Setting interface control
Use the following procedure to set or change the interface control value.
1. Use the Craft password to gain access to the Admin Procedures screen. The default
password is 27238.
2. When you select INT... from the Admin Procedures screen, the following text displays with a
prompt to use the Right and Left navigation arrows to select a setting:
The values shown are the text strings associated with the current PHY1STAT on the
Ethernet line and the current PHY2STAT system value on the PC Ethernet line.
The PHY1STAT text strings are:
● "Auto" when PHY1STAT = 1
● "10Mbps half" when PHY1STAT = 2
● "10Mbps full" when PHY1STAT = 3
● "100Mbps half" when PHY1STAT = 4
● “100Mbps full” when PHY1STAT = 5
● “1000 Mbps full” when PHY1STAT = 6
Ethernet:
PC Ethernet:
Choice Selector
Choice Selector
To Next Page
Loading...
