Local administrative options
46 SIP Deskphones Release 6.4 Installation and Maintenance Guide
● “Off” if DOT1X = 2
For the Supplicant:
● “Off” if DOT1XSTAT = 0
● “On” if DOT1XSTAT = 1
● “On with multicast” if DOT1XSTAT = 2
3. To change the setting, select the line you want to change and press the Change softkey or
the Right (or Left) navigation arrow to cycle through the settings.
4. Press Save to store the new setting and redisplay the Craft Local Procedure screen.
Note:
Note: The deskphone restarts if you make any change to the 802.1X data.
Preinstallation checklist for static addressing
Before performing static programming of address information, verify that all the requirements
listed in
Verify these network requirements on page 23 are met. You do not have to consider
item 4 in this list, as it refers to the DHCP server. In addition, you must have the values for the
following parameters. Failure to do so can cause data entry errors that prevent the deskphone
from working. Such errors can also have a negative impact on your network. Print copies of this
checklist for each subnet.
1. The IP Address of the deskphone.
2. The IP Address of the router.
3. The IP subnet mask.
4. The IP Address of the HTTP and/or /HTTPS server.
5. The IP Address of the DNS Server.
6. The VLAN ID (the L2QVLAN value).
7. The VLANTEST value.
To Next Page
Loading...
