Enabling and disabling event logging
Issue 5 August 2014 55
Note:
Note: A PHY1STAT value of 6 applies only to deskphone models that support Gigabit
Ethernet (GigE), otherwise this value/choice does not display.
The PHY2STAT text strings are:
● "Disabled" when PHY2STAT = 0
● "Auto" when PHY2STAT = 1
● "10Mbps half" when PHY2STAT = 2
● "10Mbps full" when PHY2STAT = 3
● "100Mbps half" when PHY2STAT = 4
● “100Mbps full” when PHY2STAT = 5
● “1000Mbps full” when PHY2STAT = 6
Note:
Note: A PHY2STAT value of 6 applies only to deskphone models that support Gigabit
Ethernet (GigE), otherwise this value/choice does not display.
3. To change the Ethernet setting, press the Right navigation arrow or the Change softkey to
cycle through the possible settings.
Depending on the current value, the next sequential text string is selected and displayed as
the setting. For example, if the current value is 10 Mbps half (2), pressing the Right
navigation arrow changes the value to 10 Mbps full (3). If the current value is 1000 Mbps full
(6), pressing the Right navigation arrow changes the value to Auto (1).
4. To change the PC Ethernet setting, select that line and press the Right navigation arrow or
Change to cycle through the possible settings.
5. Press Save to store the new setting(s) and redisplay the Admin Procedures screen.
Enabling and disabling event logging
Use the following procedure to enable or disable logging of system events.
1. Use the Craft password to gain access to the Admin Procedures screen. The default
password is 27238.
To Next Page
Loading...
