Server Administration
70 Deskphone SIP 9608, 9611G, 9621G, 9641G Administrator Guide Release 6.0.1
IAs shown in DHCPACK setting of parameter values, the 9600 Series IP Telephone sets the
parameter values to the DHCPACK message field and option contents shown.
DHCPACK setting of parameter values
Since the DHCP site-specific option is processed after the DHCP fields and standard options,
any values set in the site-specific option will supersede any values set via DHCP fields or
standard options, as well as any other previously set values. Values that can be set using the
DHCP site-specific option are listed in Parameters set by DHCP in a site-specific option
on
page 65.
Parameters L2Q, L2QVLAN, and PHY2VLAN are not set from a site-specific option if their
values were previously set by LLDP. For more information, see About
Link Layer Discovery
Protocol (LLDP).
HTTP Generic Setup
You can store the binary file, upgrade file, and settings file on an HTTP server. With proper
administration, the deskphone seeks out and uses that material. Some functionality might be
Parameter Value Set to
DHCP lease time Option #51 (if received).
DHCP lease renew time Option #58 (if received).
DHCP lease rebind time Option #59 (if received).
DOMAIN Option #15 (if received).
DNSSRVR Option #6 (if received, which might be a list of IP Addresses).
HTTPSRVR The siaddr field, if that field is non-zero.
IPADD The yiaddr field.
LOGSRVR Option #7 (if received).
MTU_SIZE Option #26.
NETMASK Option #1 (if received).
ROUTER Option #3 (if received, which might be a list of IP Addresses).
SNTPSRVR Option #42.
To Next Page
Loading...
