Administering options for the 9608, 9611G, 9621G, and 9641G SIP Deskphones
Issue 1 May 2011 95
ICMPRED 0 Controls whether ICMP Redirect messages will be
processed. Values are:
0 = Redirect messages will neither be transmitted
nor received Redirect messages will be supported
1 = Redirect messages will not be transmitted, but
received Redirect messages will be supported per
RFC 1122
INGRESS_DTMF_VOL_
LEVEL
-12 RFC 2833 Digit event "volume" level. The power
level of the tone, expressed in dBm0 after
dropping the sign. (from RFC 2833 section 3.5
"Payload Format." Values are: -20 to -7.
INTER_DIGIT_TIMEOUT 5 This is the timeout that takes place when user
stops inputting digits. The timeout is treated as
digit collection completion, and when it occurs, the
application sends out an invite. Range in seconds
of 1 to 10.
IPADD 0.0.0.0 IP Address of the deskphone. Range is 7 to 15
ASCII characters (less than the default string
length) defining one IP Address in dotted-decimal
format.
L2Q 0 Requests 802.1Q tagging mode (auto/on/off).
Values are:
0 = auto
1 = on
2 = off
L2QAUD 6 Layer 2 audio priority value. Range from 0 to 7.
L2QSIG 6 Layer 2 signaling priority value. Range from 0 to 7.
L2QVLAN n/a 802.1Q VLAN Identifier (0 to 4094). Null (" ") is not
a valid value and the value cannot contain spaces.
This parameter is preserved in RAM which
survives reset and stored to flash (as
L2QVLAN_INIT) only upon successful registration.
This value is initialized from L2QVLAN_INIT after
power-up. This value will not be initialized from
L2QVLAN_INIT after reset, but can be modified
using the ADDR craft procedure.
LANG0STAT 1 This flag defines, whether or not the built-in
English is offered to the user as selectable item in
the language selection UI menu. At least one other
language file must be downloaded, before "not
offering" built-in English. Values are 0=not offered;
1=selectable.
Parameter Name Default
Value
Description and Value Range
13 of 30
To Next Page
Loading...
