Setting the audio path
Sets your phone to receive calls on the Speaker or the Headset.
Procedure
1. Press Home.
2. Tap Settings.
3. Tap Options & Settings.
4. Tap Call Settings.
5. On the Call Settings menu, tap Audio Path.
6. Tap the setting to toggle between the available choices.
• If the current setting is Headset, tapping that line changes the audio path to speaker.
For example, if the current setting is Speaker tapping that line changes that setting to
Headset. Tapping the setting again changes it to Speaker.
7. Tap Save to save the setting or Cancel to return to the menu without saving.
Note:
Depending on how your administrator has configured your deskphone, you might not
have the option to change the audio path as stated above.
Setting Headset Signaling
About this task
You can set your deskphone to ring through your wireless headset and the speaker. This might be
convenient if you want to turn the speaker alert off or you have a wireless headset.
Note:
Not all headsets support audible alerts.
Procedure
1. Press Home.
2. Select Options and Settings.
3. Select Call Settings.
4. Select Headset Signaling.
5. Select and tap the line to change the setting from the following three settings:
• None: The phone does not sent a ringing tone to the headset. Headset remains on-hook
till headset switchhook button is pressed to answer an incoming call.
• Switchhook and Alerts: Every 5 seconds an alert tone is played in the headset on an
incoming call. You can use either the switchhook button of the headset or the switchhook
button on the phone to answer an incoming call.
Customizing your phone
May 2016 Using Avaya 9621G/9641G/9641GS IP Deskphones H.323 55
Comments on this document? infodev@avaya.com
To Next Page
Loading...
