The DN appears on the handset display. The status of the subscription record
changes from Enabled to Subscribed.
For information, see Subscription management on page 123.
SIP Line Gateway configuration
There are no specific SIP
DECT configuration requirements for SIP Line. For information about
installing and configuring SIP Line Gateway, see Avaya SIP Line Fundamentals,
NN43001-508.
When configuring SIP Line Gateway for use with a SIPL configuration, ensure that you
configure the following parameters:
• While enabling the SIP Line Service and configuring the root domain, enter a User agent
DN prefix (which is required for UEXT SIPL configuration) and root domain name that are
the same as the values you entered for the SIP DECT domain name
Configuring SIP
Settings on page 96.
• While Configuring SIP Line gateway node, enter the same domain name (case-sensitive)
as you entered for SIP DECT and SIP Line service, and ensure that the SIP LINE Gateway
local SIP port corresponds with the Proxy port.
Configuration of Universal Extension on a Call Server
Universal Extension (UEXT) redirects incoming calls to the DAP
. Key 0 corresponds with the
DN, configured on the DAP. Key 1 HOT U is the same number with a User agent DN prefix
configured for SIP Line.
Use LD 15 to configure station control password length before you configure the UEXT for SIP
Line users.
Table 16: LD 11: Configure station control password length
Prompt Response Description
REQ CHG
TYPE FFC FFC_DATA
CUST n n = customer number
SCPL x x = the maximum length of the password
Use LD 11 to configure UEXT.
Packages 139, 415, and 417 must be enabled on the Call Server
.
System configuration
106 SIP DECT Fundamentals October 2012
Comments? infodev@avaya.com
To Next Page
Loading...
Need help?
General
