Figure 59: Contents of the box
3.
Remove the foam contents from the cabinet.
4. At the right hand side of the cabinet, you must drill a hole for the cable inlet. Mark
the hole as shown in
Figure 60: Position of the hole in the cabinet on page 218.
Figure 60: Position of the hole in the cabinet
5. Drill a hole for the swivel. Use a 12 mm drill.
Figure 61: Drilling the hole (12 mm)
Install the external housing
218 SIP DECT Fundamentals October 2012
Comments? infodev@avaya.com
To Next Page
Loading...
