In Figure 19: Cell contour of the closest adjacent critical point to the initial critical
point on page 49, P2 is the closest adjacent critical point to the first critical point.
Figure 19: Cell contour of the closest adjacent critical point to the initial critical point
Use the following procedure to locate the cell center
.
Locating the cell center
1. Place the deployment tool at one critical point and then use the deployment handset
to obtain a change in audio quality. The audio quality change determines the cell
boundary contour.
2. Repeat step 1 at an adjacent critical point. The call center is where the cell
boundaries of both critical points meet. Mark the cell center position on a floor
plan.
3. Use the cell contours to locate a cell center.
Locate the cell center where the cell contours meet. Choose a position on the floor
plan that meets the following requirements:
• is farthest from the critical points
• provides good audio quality at the critical point,
• complies with the requirements described in section
Deployment
requirements on page
19
• is in the coverage area
Label the cell center on the floor plan with the following symbol. xCn, where x = the
floor and n = is the cell number in sequence of the entire plan.
System deployment
SIP DECT Fundamentals October 2012 49
To Next Page
Loading...
