Record
mode
Input Resolution Maximum Recording Framerate per ch
4ch 8ch 16ch
720 mode
(1280x720)
720/1080 1280x720 12fps 12fps 12fps
640x360 15fps 15fps 15fps
1080 mode
(1920x1080)
720 1280x720 10fps 10fps 7fps
640x360 15fps 15fps 7fps
1080 1920x1080 5fps 5fps 5fps
1920x540 10fps 10fps 7fps
1280x720 10fps 10fps 7fps
640x360 15fps 15fps 7fps
Each record mode is applied from ch1 to ch 4, from ch 5 to ch 8, from ch 9 to ch 12 and
from ch 13 to ch 16, as follows.
RESOLUTION
Set the resolution for the specified channel: 1920x1080, 1920x540, 1280x720 and
640x360.
FRAME RATE
Set the frame rate for the specified channel. The sum of the frame rate values from
each channel cannot exceed the maximum frame rates for a specific recording
resolution by the specific recode mode.
* It is possible to use 1080p camera and 720p camera at the same time. Please
note that the system has to be booted after connecting all cameras on the
system.
QUALITY
Select the recording quality for the specified channel. Options are: Level 1 (Low), 2, 3, 4
and 5 (High)
RECORDING
Assign the recording mode for each channel. Options are: Continuous, By Motion, By
Sensor, By Schedule or Disable.
SENSOR
RECORDING
Enable setting up to 4 sensors for the specified channel using the control button (
◀ ▲
▶ ▼
).
PRE RECORD
Enable/disable pre-event recording. Pre-event recording time is 15 seconds to 20
minutes(Selectable)
POST EVENT
RECORD
Set the post event recording time duration for the specified channel. (10-60 seconds)
AUDIO
Enable/disable audio recording for the specified channel.
SCHEDULE
Set the recording schedule. Press SEL to go to schedule setup screen.
To Next Page
Loading...