Model E1010 Indicator User Instructions 47
13. Press SELECT key twice to exit the serial test…
SERIAL is displayed.
14. Press the SELECT key…
TEST is displayed.
15. Press the UNITS key…
AUDIT is displayed.
16. Press the PRINT key…
CFG is displayed. This stands for the configuration audit counter.
17. Press the PRINT key to see the number of times the configuration has been
altered on this indicator. After a few seconds…
CFG is displayed.
18. Press the UNITS key…
CAL is displayed. This stands for the calibration audit counter.
19. Press the PRINT key…
The number of times the indicator has been calibrated is displayed.
20. After a few seconds…
CAL is displayed.
21. Press the ESC key…
The display returns to normal operation mode.
This completes the User menu.
Audit counters cannot be reset.
To Next Page
Loading...
Need help?
General
