46
Model E1010 Indicator Service Manual
ACC (Accumulator Application)
Supervisor Menu—SETUP submenu (continued)
9. Use the TARE or UNITS key to toggle between the ON and OFF choices.
Press the PRINT key when your selection is displayed…
If you choose ON go to step 9a. If you choose off, skip to step 9b.
9a. If you choose ON …
PLU 0 is displayed. See note at left.
Press the PRINT key…
A numeric entry screen is displayed.
Key in a tare value for PLU 0 and press ENTER to accept it
OR
Scroll to any PLU you want by using the TARE or UNITS key, press the
PRINT key and then key in the tare value and press ENTER to accept it.
The PLU number is shown
Repeat scrolling to a PLU and entering a value until you are finished, then
press SELECT…
TARE is displayed.
9b If you choose OFF…
TARE is displayed. With PLU tares disabled, the user can enter
keyboard or pushbutton tares during normal weighing operations.
10. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for each PLU. WARNING - Only do this if you are sure
you want the information permanently removed!
You may want to print out the reports before clearing all the
information.
11. Press the PRINT key…
SURE? is displayed.
12. Press the ESC key to abort the save process or press the ENTER key to
clear all the information…
CLEAR is displayed.
13. Press the SELECT key…
PLU is displayed.
14. Press the UNITS key…
ACC. is displayed. This stands for the accumulator application.
15. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of
accumulator totals.
16. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
With PLU tares enabled, you
cannot enter keyboard or
pushbutton tares. PLU tares
and the other tares are mutually
exclusive per NTEP rules.
To Next Page
Loading...
Need help?
General
