47
Model E1010 Indicator Service Manual
Supervisor Menu—SETUP submenu (continued)
BATCH
(Batch Application)
17. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for this application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the report before clearing all the informa-
tion.
18. Press the ENTER key…
SURE? is displayed.
19. Press the ESC key to abort the save process or press the ENTER key to
clear all the information…
CLEAR is displayed.
20. Press the SELECT key…
ACC. is displayed.
21. Press the UNITS key…
BATCH is displayed.
22. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of
batch information.
23. Press the ENTER key …
Display shows BUSY briefly then returns to PRINT.
24. Press the UNITS key…
TYPE is displayed. Use this item to set the type of the batching
application to Automatic or Manual
AUTO In this mode you start the batch by pressing the F1 key.
Output #1 activates and OP1 annunciator lights. When the
weight reaches the configured cutoff value, output #1 turns
off. Output #2 automatically activates and OP2 lights to
continue the batch. This pattern repeats through output #2
and #3.
MAN. In manual mode, the user presses F1 to start the batching
process. As each output weight is met the output deacti-
vates and the user must press the F1 key to activate each
subsequent output.
25. Press the PRINT key…
The current type setting is displayed.
26. Toggle between the choices by pressing the TARE or UNITS key. Press
the ENTER key when your choice is displayed…
TYPE is displayed.
To Next Page
Loading...
Need help?
General
