VENUE System Restore 15
VENUE System Restore
If you are configuring a system for the first time, or whenever no Software Update is available, you should install the most recent
VENUE System Restore software on both your E6L engine and S6L control surface.
VENUE software, plug-ins for your system, and additional software are accessed from your Avid account after you have activated
your purchase.
Follow the instructions in this section to perform a System Restore. If you are performing a System Restore on a system that has
already been in use, be sure to follow the instructions in
Backing Up System Settings before proceeding.
System Restore Software Installation Overview
After Unpacking and Assembling Basic System Components, and Activating S6L System Components, getting your sys-
tem up and running with the latest software consists of the following general steps:
• Downloading VENUE System Restore software
• Creating two System Restore USB Drives (one for the E6L engine and one for the S6L control surface)
• Installing E6L engine System Restore software on the E6L Engine
• Installing S6L control surface System Restore software on the S6L control surface
To begin, proceed to
Downloading VENUE System Restore Software.
The screens and text displayed on your system may differ slightly from the images shown on the following pages.
To Next Page
Loading...
