IFD500 Series Pilot Guide
FMS Subsystem 3-43
Additionally, there is a setting to enable or disable visual
approaches. When set to disabled, visual approaches will no
longer be presented in dropdown menus.
IMPORTANT NOTE
Once a visual approach has been inserted into the
flight plan, it retains the settings that were in effect
when it was inserted. To change the final length,
pattern width, or glideslope of the approach in the
flight plan, the settings must be changed on the
Setup page, and then the approach must be
reinserted into the flight plan.
ACTIVATING A LEG
To activate a different leg of the flight plan from the FPL tab,
either use the bottom right knob or touch the desired leg to
highlight it and then select the “Activate Leg” LSK.
Activating a Leg
To Next Page
Loading...
