IFD500 Series Pilot Guide
7-44 General
CHARGING FROM THE USB
The USB port on the front of the IFD bezel is a USB v1.1
compatible USB port which can be used as a power source for
charging devices.
The capacity of the USB port is dependent upon the installation.
For 14V installations, the USB port will function as a low power
charging port, delivering up to 1 amp. For 28V installations, the
USB port will function as a high power charging port, delivering
up to 2.1 amps.
High power devices, such as iPads, can be charged using a low
power port. However, in order to continue using the device while
it is being charged, the device must be connected to a high power
port (therefore, only in a 28V installation).
TIPS AND TECHNIQUES
Use of USB Port at Startup
If a device is plugged into the bezel USB port at IFD
startup, the unit will boot into maintenance mode.
Unless you are intentionally trying to enter
maintenance mode at startup, ensure there are no
devices inserted in the bezel USB port at startup.
The USB port can be used immediately after IFD
initialization.
To Next Page
Loading...
