AvMap G7 Farmnavigator - 4. Advanced operating modes; 4.1 Start new job, full mode; 4.2 Define the field and create new A-B guidelines

45
AvMap G7 Farmnavigator – User Manual
4. Advanced operating modes
This chapter describes advanced operative functions.
4.1 Start new job, full mode
To start a new job in full mode, it is necessary to insert all the information required for a correct
registation of a new job:
1. Select “START NEW JOB”;
2. At “FARMER” line, tap the downward green arrow and select the farmer’s name;
3. At “FIELD” line, tap the downward green arrow and select the eld. In case of undened
eld, tap on “Create New” and follow the procedure for inserting a new name;
4. At “IMPLEMENT” line, tap the downward green arrow and select implement’s name;
5. At “DRIVER” line, tap the downward green arrow and select driver’s name;
6. At “PRODUCTS” line, tap the downward green arrow and select the name of the product. It
is possible to select more than just one product for every single job;
7. Select “OK” to go to work page;
8. Tap the “i” located at the upper left corner of the display to edit Job name:
1. Tap the pen icon to modify the text;
2. Select “OK”;
3. Tap on the downward green arrow to go back to the previous page;
4. Tap on “A-B” to start the job.
4.2 Define the field and create new A-B guidelines
During the denition of the eld, it is possible to create A-B guidelines to work the area inside the
eld boundaries. This procedure is to be used the rst time you dene the eld.
In this way an A-B line is created in conjunction with the passage of the tractor on that side of the
eld, avoiding unecessaries overlaps.
- Create a new Job, preferably in full mode.
- Move to the edge of the eld;
NOTE: It is advisable to change the name of the job. In order to do so, tap on “i” located at the top
left corner of the display.
- Tap “START” if the area must be worked during the recording of the boundaries;
- Tap “FIELD” and move along the perimeters of the eld;
- On the Job side, tap “A-B”;
- Select the line type;
- Proceed straight ahead to save point B;
- Tap B and proceed straight ahead to close the contour;
- Tap “FIELD” to complete registration, when you are in proximity to the starting point;
- The eld takes the name dened during the new job creation page. Tap “EDIT” if you want
to modify it;
- Field boundaries will be saved and stored.