Chapter 3: Operations 33
7. Select the Receiver or Transmitter Menu by pressing 1 or 2 and pressing Enter. You will be
prompted to enter a password.
8. Type the password and press Enter.
NOTE: If there is no transmitter connected to the HMX user station, an error message will display and you will be
returned to the Appliance Selection Menu.
Navigating the serial menu
To navigate through the serial menu, type the number or letter that corresponds to the option you
wish to choose and press
Enter. This action will bring you to a sub-menu or screen where you can
make configuration changes. To exit a menu or screen and to confirm any configuration changes
you have made, type
0 (zero) and press Enter.
Configuring Network Settings
Each HMX system component is shipped with default network settings preconfigured. You can
change the default values using the serial menu.
NOTE: IP address data can be obtained by DHCP or can be set to Static (default).
NOTE: It is recommended that you configure the network settings for the transmitter before you configure the
network settings for the HMX user station.
To configure network settings for the transmitter:
1. Press Enter to display the serial menu. The Appliance Selection Menu displays.
2. Press 2 to access the Transmitter Menu. If the password option is enabled, you will be
prompted for a password.
3. Type the password and press Enter. The Transmitter Main Menu will appear.
Figure 3.8: Transmitter Main Menu
To Next Page
Loading...
Need help?
General
