Chapter 3: Operations 53
Figure 3.31: Advanced Video Settings Menu
4. Enter the number that represents the port to which you wish to set the EDID preferred timing,
then enter
0 (zero) to Exit/Apply Changes or enter c to Cancel.
Figure 3.32: EDID Settings Menu
5. Enter the number that represents the desired preferred timing, enter 0 (zero) to Exit/Apply
Changes or enter
c to Cancel.
Session retry settings
The HMX user station is designed to automatically establish a connection between the HMX user
station and the remote workstation. By default, if the HMX user station cannot immediately
establish a connection with the remote workstation it will retry once per second until a connection
is successfully established. You can change the default session retry settings using the serial menu.
To access the Session Retry Menu:
1. Press Enter to display the serial menu.
To Next Page
Loading...
Need help?
General
