40 HMX Extender System Installer/User Guide
7. Press 1 to select Management Appliance IP Address.
Figure 3.18: HMX Manager IP Configuration Menu
8. Type a valid IP address and press Enter.
9. Type 0 (zero) and press Enter to return to the Network Configuration Menu.
10. Type 0 (zero) and press Enter to return to the Main Menu.
- or -
If you do not want to save changes made in the Management Appliance IP Configuration
Menu, Type
C (or cancel) and return to the Main Menu.
Detecting a transmitter IP address
In the event that you forget the IP address of a transmitter, you can use the serial menu to detect the
IP address of a transmitter that is connected to the HMX user station.
NOTE: This can only be done if the transmitter has been assigned a static IP address.
To detect the IP address of a connected transmitter:
1. Turn off the transmitter and directly connect it to the user station.
NOTE: If the transmitter receives its power from an external power supply, disconnect the transmitter from that
external power supply.
To Next Page
Loading...
