Chapter 4: Accessing the PM PDU via the Command Line Interface 53
**:- ipv6 cli-> set enable_ipv6/ get_dns_from_dhcpv6=yes
**:- ipv6 cli-> set enable_ipv6/ get_domain_from_dhcpv6=yes
7. Enter show to verify the change.
**:- ipv6 cli-> show
enable_ipv6 = yes
get_dns_from_dhcpv6 = yes
get_domain_from_dhcpv6 = yes
enable_bonding = no
8. Enter commit.
CLI Overview for Administrators
This section describes using the Command Line Interface for administrators. Only administrators
and authorized users can access the commands listed in this section. These procedures assume you
have logged into the CLI as an administrator and are at the --:- / cli-> prompt.
NOTE: In the tables that show output from the show command, when an option that is followed by an equal sign
(=) is left blank, that option is not assigned a value by default.
System
1. Enter cd system to navigate to the System level.
--:- / cli-> cd system
2. Enter show to view the available options.
--:- system cli-> ls
security/
date_and_time/
help_and_language/
boot_configuration/
information/
usage/
3. Enter show followed by an option name to view information about each option.
--:- security cli-> show security_profile
System/Security
Enter cd security to navigate to the security level.
To Next Page
Loading...
Need help?
General
