62 Avocent PM PDU Installer/User Guide
Network/SNMP
Enter cd network/snmp to navigate to the snmp level.
--:- / cli->
cd network/snmp
Type add then press Return to start configuring a new snmp community:
--:- snmp cli->
add <Return>
--:#- [snmp] cli-> show
name =
oid =
permission =
version = version_v1|v2
source =
--:#- [snmp] cli-> set name=public
--:#- [snmp] cli-> save
--:- snmp cli-> show
name version source oid permission
==== ===== ===== ====== ==========
public v1/v2 default read and write
--:- snmp cli-> system
--:#- [snmp] cli-> show
syscontact = Avocent_Corporation
syslocation = Avocent_PM
Wiz command
The wiz command allows administrators to easily and quickly perform the initial network
configuration of the eth0.
At the command prompt at the / level, enter
wiz to view the current IP configuration. To change the
IP configuration, press
Tab to move through the parameters, and press Esc + Tab to edit the
selected parameter. When you are finished, enter
yes to confirm that all parameters are correct and
to save the new parameters.
--:- / cli-> wiz
current ipv4 address: 172.26.30.249
current ipv6 address:
eth0:
To Next Page
Loading...
Need help?
General
