AVOCOR F Series User Manual

Revision Date: 1/17/2020
45
Network Configuration
This menu configures the display’s RS232 and Ethernet communication ports.
UART Baudrate
Select the baud rate of the display’s RS232 port
Options: 115200, 38400, 19200, 9600; Default: 115200
Network
Enable the display’s built-in Ethernet port
Options: No, Yes; Default: No
IP Address
Enable Dynamic IP mode or set the static IP address of the display’s Ethernet port
Default: 0.0.0.0
Netmask
Set the subnet mask address.
Default: 0.0.0.0
Gateway
Set the Gateway mask address.
Default: 0.0.0.0
DNS
Set the DNS mask address.
Default: 0.0.0.0
Save Settings
Save the network settings and apply to device.
Refresh
Refresh dynamic IP information.
Power Status Alert
Enable an automatic alert when the display is powered down
Options: On, Off; Default: Off
Source Status Alert
Enable an automatic alert when the source is changed
Options: On, Off; Default: Off

AVOCOR F Series Specifications

General

Brand	AVOCOR
Model	F Series
Category	Monitor
Language	English