44 USER MANUAL
____________________________________________________________________________________________________________________
Buzzer option is used for selection of
acoustic signalling method. Selection of
Stable OK option means acoustic signal
activation after indications stabilisation
in range signalled as OK. It is possible
to activate the signal immediately after
exceeding the threshold, or total signal
deactivation.
To start working with thresholds
signalling, move cursor to Activate
option and press ENTER.
After each loading, the result of
comparing with thresholds is
signalled.
To finish the function operation,
press MENU to enter the user
functions menu, select Threshold
signalling function, and select
Deactivation option.
If the balance is equipped with THRESHOLDS control connection, the comparison
result may be used to control the external optical signalling device, or other
external devices.
On the outputs P1 and P2 the short-circuit states appear, which depend on
comparison results of balance indications with threshold values. The available
operation modes are shown on the states chart.
To Next Page
Loading...
Need help?
General
