Axon Fleet 3 Installation Guide

Axon Fleet 3 Installation Guide
Axon Enterprise, Inc. Page 25 of 47
7. Prepare source end of the Power and Signal Harness for connection to vehicle
power/activation sources. Any inputs not being used should be taped back with Tesa
tape or similar.
Installing the Router and Exterior Antenna
For installation of the router and the antenna, refer to the appropriate manufacturer’s
instructions for installation.
• Cradlepoint installation (
https://customer.cradlepoint.com/s/article/Vehicle-
Installation-Guide-for-COR-Series-Mobile-Routers)
• Airgain Antenna Installation (https://airgain.com/installation-and-removal-guides/)
1. Install router and exterior antenna.
2. Route an Ethernet cable from the router to the MDC mounting location.
3. Route an Ethernet cable from the router to the Hub mounting location.
4. Route the router power, ground, and ignition cables to the planned Power and Signal
Harness location.

Axon Fleet 3 Specifications

General

GPS	Yes
Connectivity	Wi-Fi, Bluetooth
Night Vision	Yes
Storage	128 GB
Battery	Rechargeable Lithium-Ion