Azbil 700 series - Procedure to Change Pilot Relay

6-16
6-9-2 Procedure to Change Pilot Relay
Step Procedure
1
Loosen three screws and remove the P cover.
(Figure 6-9)
2
Loosen four screws and remove the pilot relay.
(Figure 6-10)
3
Tighten a new pilot relay with four screws.
(Torque: 1.8±0.2N • m)
4
Tighten the P cover with three screws.
(Torque: 1.5±0.2N • m)
Handling Precautions:
Please make sure that the O-ring does not fall off when assembling the pilot relay.
P cover
Figure 6-9 Removal of P cover
Pilot relay
Figure 6-10 Removal of pilot relay