Azbil 700 series - Local User Interface (LUI)

3-2
3-1 Local User Interface (LUI)
Four push buttons on the LUI (with , , , and symbols) can be
operated by removing two screws ((2.5-mm) hexagonal socket bolts) from the
front cover of the device.
Front cover
Hexagonal
socket bolts
Operation
buttons
Figure 3-1 LUI Structure with the Front Cover Removed
Table3-1
Key input Monitor mode Setup mode
Switches between display categories. Goes to the next display.
Selects the next item.
Selects the previous item.
Switches between display categories. Goes back to the previous display.
Hold down Switches between setup mode and monitor mode.
Hold down Executes the function.
The LUI supports the monitor and setup modes.
In monitor mode, the normal, detailed and status are available. The normal
monitor can be used to monitor data such as opening and input signals and it
displays alarm information if a self-diagnostic alarm is issued.
To change from monitor mode to setup mode, hold down the
button. In
setup mode, operations such as auto setup and zero span adjustment can be
performed. Figure 3-2 shows a diagram of the LUI screen transition.