2-8
[Example of double-acting rotary cylinder actuator]
SpacerAVP
Spring washer
Hexagonal bolt
Arm
Spring washer
Hexagonal nut
Feedback lever
Feedback pin
Spring
washer
Figure 2-5 Mounting Procedure for Double-Acting Rotary Cylinder Actuator
3) Mounting procedure
The procedure for mounting the feedback lever onto the actuator is shown below.
Step Work
1
Tightly secure the mounting plate by inserting hexagonal bolts
(M8×20) with spring washers into the (two) screw holes at the
rear of the device.
2
Tightly secure the device (mounting plate) onto the mounting
seat of the actuator by using bolts and washers. At this time,
insert the actuator feedback pin into the slotted hole of the
feedback lever in the device.
To Next Page
Loading...
