Azbil 700 series - Page 32

2-16
2) Terminalforexternalgrounding
Connect the external grounding terminal to the case with two washers as follows.
Figure 2-17 Connection of External Grounding Terminal
3) Without motion transmission (model AVP702)
Remove the terminal box cover and connect the wires as shown in the figure below.
Figure 2-18 Electrical Wiring without Motion Transmission (2-conductor cable)
Use only one of the two ground terminals (internal or external) and perform the ground
work according to all local laws and ordinances governing electrical work.
4) With motion transmission (model AVP701)
Remove the terminal box cover and connect the wires as shown in the figure below.
Figure 2-19 Electrical Wiring with Motion Transmission (4-conductor cable)
• Use the following wiring method if the monitoring system is a voltage input (1 to 5 V)
device.
Washer
Washer
Cable lug
Controller
Ground
At least 250Ω
Monitoring system
(current input)
Controller
*1
*1 : For the detailed information of the power supply and resistor,
please refer to the gure 2-18 of 2-3-4 Input Signals and Travel
Analog signal
DC4 - 20mA
Ground